![]() ![]() Ping 169.254.5.180 succeeded Socket configuration After pressing the PINGīutton, you should see the following message printed: It the Pickit ROBOT connection IP address. The robot controller, you can create a new host name ‘pickit’ and give To verify now if a network connection can be made between Pickit and Set the correct IP address and subnet mask for Port 1 or Port 2.Īctivate these new settings via NEXT > INIT. In case of using an older software version, you might have to To get you started as quickly as possible, Pickit provides:Īll ASCII files for both the low-level communication as well as anīinaries generated from these ASCII files for software version V7.70, V8.30 and V9.10. Information on the installed software can be found in the followingįile: ~/backup/All Of Above/orderfil.dat. Note thatĪlso the software version (V8.30P in the above example) can be verifiedĪlternatively, a backup of the controller can be made and the Here you can check now if the module is listed as shown below. ID page by opening MENU > STATUS > Version ID and then click the ORDER FI button. To verify if that software module is installed open the Status version Software module User Socket Msg for socket communication is required (the product number for this module is A05B-2600-R648). ![]() Pickit is compatible with controllers as of version R-30iA (i.e. ![]() Check controller and software compatibilityĬheck controller and software compatibility ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |